Is your trunk lock stuck and impossible to open despite all your attempts? Is the lock not functioning properly? Are you feeling like you're about to smash your rear window just to get your things out? Don’t panic! In this guide, we’ll show you how to unlock your trunk and walk you through the steps to replace the lock so you can avoid similar issues in the future.
What is the trunk on a moped car?
You might be wondering, what exactly is a trunk, and where is it located? Think of it as the door to your vehicle's storage area. The trunk is simply part of the rear section of your moped car, made up of a single door and rear window. But why don’t we just call it a “storage area”? Is there a difference? It’s a bit tricky to explain, but practically speaking, it’s simple. The storage area is the compartment in the car where you store things. A storage area doesn’t necessarily need to have a trunk (a door with a rear window); it could, for example, have double doors instead. However, a trunk cannot exist without a storage area. Pretty simple, right?
What happens if the trunk lock is broken? How do you know?
If you can’t open your storage area and the trunk is stuck in the closed position, it could be the lock causing the issue. If this sounds like your situation, don’t worry! In the guide below, we’ll show you an easy and effective way to unlock the trunk on your moped car so you can replace the broken lock.
How to replace a broken trunk lock on a moped car
To replace a broken trunk lock on your moped car, you will need:
- A 4 mm Allen wrench
- A new trunk lock that is compatible with your moped car
- Possibly a new electrical connector for the trunk lock if that’s also damaged
Time required: Approximately 30 minutes if done by one of our experts.
Step-by-step guide to replacing the trunk lock on a moped car:
If the trunk on your moped car is stuck in the closed position, you can unlock it from inside the vehicle. Use a narrow, pointed tool like an Allen wrench or a screwdriver to activate the lock lever from the inside.
Here’s how you can replace the lock:
1. Start by removing the clip that holds the lock cover in place.
2. Use the 4 mm Allen wrench to remove the two screws holding the lock mechanism in place.
3. Pull out the lock from the trunk to replace it. It is usually attached with a cable.
4. Disconnect the lock's sensor by gently prying it loose.
5. Take your new trunk lock and connect the sensor.
6. Place the new lock into its mount in the trunk.
7. Tighten the two screws with your 4 mm Allen wrench.
8. Replace the cover over the lock mechanism.
9. Reattach the clip to secure the cover.
Congratulations, you’ve successfully replaced the trunk lock on your moped car!
For more tips and parts for your moped car, visit minicarspares.